Spot Cooler - How It Works
Compressed air enters at point (A) into
the vortex tube component of the spot
cooler. The vortex tube splits the compressed
air into a hot (B) and cold (C) stream
of air. The hot air from the vortex tube
is vented to the atmosphere at point (D)
after being muffled to reduce noise. Cold
air enters into the muffler (E) and then
distributed through the hose distribution
kit (F) and onto the item being cooled.
A strong magnet (G) holds the spot cooler
in place. The temperature of the cold
air is controlled by an adjustable knob.
Mini Spot Cooler - Frigid-X Mini Spot Cooler
The Mini Spot Cooler utilizes a vortex tube to create one hot stream and one cold stream. The cold air produced at the cold end is directed to the surface to be cooled using a flexible hose.
Cold air is directed using
the flexible tubing. A magnetic base is
standard for portability and easy mounting
of the mini spot cooler.
Units are available with
either a single point hose kit for small
surface area mini spot cooler or a dual
point hose kit when heat is generated
over a larger surface area.
Mini spot cooler produces
a wide range of airflow and temperature
by adjusting the knob at the hot end and
changing the various generators supplied.
The generators control the
air consumption and are easily interchangeable.
Mini spot cooler has a 25
SCFM (708 SLPM) generator installed that
will produce up to 1,800 Btu/hr. of cooling.
If less is required, the 15 SCFM (425
SLPM) generator can deliver 1,100 Btu/hr.
If more cooling is needed
Nex Flow can supply you with the
30 SCFM ( 850 SLPM) generator for up to
2,100 Btu/hr. of cooling.
plastic machined parts
hot melt adhesives
welding horns on ultrasonics
heat shrink tubing